Dishnet installation how to

Home customer service. New Customers Order service for your home or business. Existing Customers Upgrade, move service, or get help with your account.

Call: Order Online. Pay My Bill. Resolve satellite connection issues. Expand All Collapse All. How do I upgrade my plan? How do I find out what channels I have? Expand All Collapse All. DISH free standard professional installation includes the following: Site survey at time of installation to determine satellite location. System peaking for optimum performance. Installation of up to feet of RG-6 cable. Orientation to DISH programming and equipment. What materials are provided at no charge?

Provided materials include the below: Up to feet of RG-6 cable. Weather sealant for connections and structure. You can also get the following customizations for no extra fees: Attic crawl. Tighten the skew bolts securely. See Table 1 for the required torque values. After the skew is set, do not try to finetune the skew angle when aiming the dish. Grounding, other devices, and in-home cabling must also meet these requirements. RG-6 coaxial cable rated for at least to MHz must be used in this installation.

Do not use existing cables such as RG as it may cause signal loss. Also, be sure that any outdoor connections are made using waterproof F-connectors rated for MHz or greater. The cable length between the DISH Damage caused by over-tightening is not covered by the limited warranty. Tighten all indoor coaxial cable connections to the receiver only by hand.

If you use a wrench, you may over-tighten the connections and damage your equipment. Connect a temporary cable to a peaking meter. Thread the other end of the cable through the LNBF arm and bracket. Attach the LNBFs to the bracket using the included screws. Do not adjust the skew. Ensure you are peaking the dish using transponder 11 or higher. With the peaking meter still connected, tighten the mast clamp and elevation bolts using the torque values listed in Table 1 on page 6.

Re-confirm signal strength after tightening the bolts. Remove the temporary cable used for peaking the dish. Thread the cable s from the receiver s through the LNBF arm and bracket. Connect a cable from DPP If a Legacy receiver is present, it should be installed last.

Connect a cable from the DPP